Successfuly Unlocked/Flashed/Repaired phones by 4SE dongle

[NANAIU]

answer: Successfuly Unlocked/Flashed/Repaired phones by 4SE dongle

4SE - tool 1.8.2
Selected model: T715
Selected operation: Unlock
Selected interface: USB (BOOTROM)
Checking USB driver status...OK (SEMC Flash Device v2.2.0.5 | 2-22-2011)
Remove battery, wait a few seconds and insert it back
Plug USB cable holding both "2" and "5" buttons
Connected to USB3
You can now release the keys and allow the process to run. Do not disconnect the phone
Device identification...OK
Sending Preloader...OK
Sending IDloader...OK
Chip

B3210 Model:T715 IMEI:35662703-135114-1 CID:53 Domain:RED
OTP LOCKED:1 CID:53 PAF:1
Uploading logic DB3210:
Detecting flash type...OK
ID: 2CAA (Micron)
Chip: Micron 2048 Mbit NAND (large page) x08
Logical address: 0x80000000
Size: 264 Mb
Reading TA security data...OK
Sending CSLoader...OK
Authenticating with key KIDP96_EMP_DUMP_R1A...OK
Reading unique device key...OK
Device key:9C4A79BD1B3A46BBB34497BDC5A72DB0
Restarting device...OK
Connected to USB3
Device identification...OK
Sending Preloader...OK
Sending ResetLoader...OK
Authenticating with key KIDP96321035...OK
Reseting to factory defaults...OK
Restarting device...OK
Connected to USB3
Device identification...OK
Sending Preloader...OK
Sending ProductionLoader...OK
Writing SEMCBOOT...OK
Changing certificate to RED...OK
Recompiling security area...OK
Shutting down device...OK
Operation completed successfully. You can disconnect the phone now
FINISHED [26sec]