This phone is intended for use with a BL-5J battery. Always use original Nokia batteries.
If you only have one SIM card, insert the card into the internal SIM card holder.
Place your finger in the recess at the bottom of the phone, and carefully lift and remove the back cover.
If the battery is inserted, lift it out.
Slide the SIM card holder to unlock it (1), and use your fingernail to lift it. Make sure the contact area would face down when the SIM card holder is lowered (2), insert the SIM card into the holder, and lower the holder (3). Slide the card holder to lock it (4).
Line up the contacts of the battery and the battery compartment, and insert the battery. To replace the back cover, direct the top locking catches toward their slots, and press down until the cover locks into place
Your battery has been partially charged at the factory, but you may need to recharge it before you can switch on your phone for the first time. If the phone indicates a low charge, do the following:
Connect the charger to a wall outlet.
Connect the charger to the phone.
When the phone indicates a full charge, disconnect the charger from the phone, then from the wall outlet.
You do not need to charge the battery for a specific length of time, and you can use the phone while it is charging.
If the battery is completely discharged, it may take several minutes before the charging indicator is displayed or before any calls can be made.
If the battery has not been used for a long time, to begin charging, you may need to connect the charger, then disconnect and reconnect it.
You may be prompted to get the configuration settings from your network service provider. For more information on this network service, contact your network service provider.
Use only compatible memory cards approved by Nokia for use with this device. Incompatible cards may damage the card and the device and corrupt data stored on the card.
Your phone supports memory cards with a capacity of up to 32 GB.
Open the cover of the memory card slot.
Make sure the contact area of the memory card is facing up, and insert the card. Push the card in, until it locks into place.
Close the cover of the memory card slot.
Important: Do not remove the memory card when an application is using it. Doing so may damage the memory card and the device and corrupt data stored on the card.
You can remove or replace the memory card without switching the phone off. Remove the memory cardPush the card in, until it is released, and pull the card out.
The antenna area is highlighted.
Avoid touching the antenna area while the antenna is in use. Contact with antennas affects the communication quality and may reduce battery life due to higher power level during operation.
Do not connect products that create an output signal, as this may damage the device. Do not connect any voltage source to the Nokia AV connector. If you connect an external device or headset, other than those approved by Nokia for use with this device, to the Nokia AV connector, pay special attention to volume levels.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.