Musakatari
Well-known Member
- Joined
- Nov 9, 2010
- Posts
- 1,460
- Likes
- 15
Step 1: You have to find a stem LPT port cable as shown:
Just like on the Jack LPT port to attach to the back of the computer.
And on what it has stated that Jack LPT number from 1 to 25 feet (see wealth in'll see). And we only care about 4 feet.
No. 6 feet ..........( called SCK)
No. 7 foot ..............( called Mosi)
No. 9 feet ..............( called reset)
foot No. 10 ............( called miso)
As shown below:
Step 2: Open Box JAF and welding as Figure 1 below.
Step 3: View behind JAF BOX. using a scalpel and cut as shown in Figure 3 below.
Step 4: Connect the USB for the JAF Box to use GND and 5V Voltage
Step 5: Download: soft + Firmware of JAF box
Step 6: Install PonyProg_V207c
Step 7: After installation is complete, we set up as shown below.
The steps to load and select the file you just need to conform to the video is 100% OK. The most important problem is the connection with JAF BOX LPT port only.
Just like on the Jack LPT port to attach to the back of the computer.
And on what it has stated that Jack LPT number from 1 to 25 feet (see wealth in'll see). And we only care about 4 feet.
No. 6 feet ..........( called SCK)
No. 7 foot ..............( called Mosi)
No. 9 feet ..............( called reset)
foot No. 10 ............( called miso)
As shown below:
Step 2: Open Box JAF and welding as Figure 1 below.
Step 3: View behind JAF BOX. using a scalpel and cut as shown in Figure 3 below.
Step 4: Connect the USB for the JAF Box to use GND and 5V Voltage
Step 5: Download: soft + Firmware of JAF box
Step 6: Install PonyProg_V207c
Step 7: After installation is complete, we set up as shown below.
The steps to load and select the file you just need to conform to the video is 100% OK. The most important problem is the connection with JAF BOX LPT port only.
YouTube - Video fix JAF by zopo.wmv
http://www.youtube.com/watch?v=uF8HrXt3i1Y
http://www.youtube.com/watch?v=uF8HrXt3i1Y