Before Open a Thread Search Here Hardware Solutions!

[josher]

iPhone 4g A4 CPU Reball Without Stencil Video Slideshow.

iPhone 4 A4 CPU Reball Without Stencil! - YouTube
Watch and like most hard was cleaning glue from board and cpu,reball can be done fast.

 

[josher]

iPhone 3GS PMIC Replace No Need Stencil,No Need Reball!

This how i replace PMIC on iPhone 3GS no need to reball only resolder each print on PMIC then on board fix and heat that is all it take around 10 minutes!
Slide show video.
iPhone 3GS PMIC Replace No Need Stencil! - YouTube

 

[josher]

iPhone 4G SWI Line Removed Filter Repair!

This how i repair if some pad is removed no need to make long jumpers.

iPhone 4G Batt SWI Line Repair! - YouTube

 

[josher]

iPhone 3GS PMIC Pinout!

 

[josher]

iPhone 4G CDMA Components Info!

 

[josher]

iPhone 4S Battery Connector Repair!

This repair if battery connector was removed with 2 middle pads,never use thick wire connector will not align properly.
iPhone 4S Battery Connector Repair! - YouTube
By the way press thanks if this helps!

 

[josher]

iPhone 4G Audio IC U62 Reball,No Sound During Call!

This method i use almost for all ic only where are big ic i can lift up some more heat or change nozzle,you can see i not use board holder that eat the heat!
iPhone 4G Audio IC U62 Reball,No Sound During Call! - YouTube

 

[josher]

Apple Products Black Resin Clean!

Give 180C of heat for harder resin give 190C that is like in iPhone 4S when do this need patience and be careful to not cut some track or remove an component,solvents are not very useful this is best i know!
Apple Products Black resin clean! - YouTube

 

[josher]

Repair Removed BGA Print With Thin Wire!

Find thin wire in wrist watch and repair any removed print with a track or component that remain.
Repair Removed BGA Print With Thin Wire! - YouTube
Press thanks bro other video coming soon!

 

[josher]

Removed Solder Pad Fix!

Be careful what you do this video is only to show how to fix in case if there is no solder pad to solder the component if it was eaten by water or removed accidentally,never do what i did in first 45 seconds!!!!!!
Removed Solder Pad Fix! - YouTube

 

[josher]

Rework of corroded components!

This procedure is made when device was water damaged,corroded components need resoldered so all connections are made again like from factory because water eats away solder and some component might loose it's connection and resoldering is the first step when device have problems!
Rework of corroded components! - YouTube