common problem difficult to solve try to make it easy

[JannatLui]

brother here the 6300 display solution step by step check ways

1)change display

2)resoldring display coonector

3)check vio 1.8 volt
a)check or change coil
b)remov blue marked this capacitor
c)make this jumber like this picture
4)check vaux 2.8v volt
a)check or change coil
b)remove red maked capacitor
c)make this jumber like this picture

5)Chnage display EMI filter(2Nos)

6)LAST CHECK RAP3G REFLOW REBALL
Regards

 

[JannatLui]

6030 HANDFREE MODE SOLUTION
1)CHECK OR CHANGE BOTTOM CONNECTOR

2)CHANGE RED MARKED 100K RESISTER OR REMOVE BLUE MARKED C2011 CAPACITOR

3)RESOLDRING OR CHANGE N2160 OR N2161 TRANSISTER

IF NOT SOLVED THIS PROBLEM?CHECK UEM

 

[JannatLui]

Booting phone...
MCU ID: 0x2201
BOOT file: C:\Program Files\ODEON\JAF\Flash\u_2nd.fia
Loader version: 04.46.01 -> Revision: 0007
Boot size is 0x09A0
Boot is ready...
FLASH ID0: 226800EC <=> SAMSUNG (SEC) -> K8S3215ETE Addr0: 0x01000000 - 0x01FFFFFF, SectorSize0: 10
FLASH ID1: 00010000 <=> Flash -> not used Addr1: 0x02000000 - 0x02FFFFFF, SectorSize1: 0
First 16 bytes: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF
Flash ID is 0x6822EC00
Flash loader is C:\Program Files\ODEON\JAF\Flash\u_amd.fia
Loader version: 04.46.01 -> Revision: 0007
Loader size is 0x7518; Loader chk: 21
Loader is ready...
P-key nokia module version 01.02
MSID: 84EF0EFDE4977274EED61AD3C8
MSID decoded: 3E4EBAE90081C788A8000000
FAID: E8DC95F68C3009F74DCF0E72
Operation took 0 minutes 18 seconds...
Erasing...
Found 5 interval(s) to erase
Erasing area: 01000000 - 0100FFFF...
Erasing area: 01010000 - 013BFFFF...
Erasing area: 013C0000 - 013EFFFF...
Erasing area: 017C0000 - 017EFFFF...
Erasing area: 01FC0000 - 01FEFFFF...
Operation took 0 minutes 24 seconds...
Writing...
Error cmd: 14!
Addr: 01000000

dear friends see this error,this is nokia 2310 flashing error with JAF?
NOKIA 1110,6030,1600,1112,2610,1200,1208,1650 Etc.........
FACED SAME FLASHING PROBLEM
WHICH PART DAMAGED THIS CAUSE
HOW TO CLEAR THIS PROBLEM
SEE TECHNICS
STEP-1
change clock crystal(RTC)

change second loacl crystal

reball or change FLASH IC

 

[JannatLui]

NOKIA 2630 OR 2600C MAIN PROBLEM INSERT SIM OR CAMEAR OPEN TIME PHONE RESTARTED

AM EXPLAINING INSERT SIM SOLUTION
1)CHANGE BATTERY
2)RESOLDING SIM CONNECTOR
3)CHECK VSIM VOLTAGE WAYS
4)CHECK VSIM LEG TO GND OHMS ANY SHOTAGE SHOW?
5)REMOVED C2208,C2700,C2710 VSIM REALETED FILTER CAPACITOR
6)REMOVE SIM IC THEN MAKE THIS JUMBER LIKE THIS PICTURE

 

[JannatLui]

nokia 5200 SIM WAYS

ALL WAYS AND JUMBERING PROPER BUT NOT TAKEN SIM CARD?
REMOVE V SIM REALTED CAPACITOR(MAKED ITEAM)

SAME PROBLEM AGAIN 100%RETU PROBLEM U MUST REBALL OR CHANGE RETU

 

[JannatLui]

N70,N72 NO OPERATOR FOUND SOLUTION REPAIRING STEP BY STEP

1)PUT SIM THEN GO MENU+TOOL+SETTING+NETWORKSETTINGS
CHANGE THIS MODE GSM
THEN CHECK PHONE NETWORK STATUS SAME NET WORK PROBLEM???
2)(A)GO MENU+TOOL+SETTING+NETWORKSETTINGS
CHANGE OPERATOR SELECTION
AUTOMATIC TO MANUUL MODE
THIS TIME PHONE GOING TO SHOT SEARCH?THEN SHOW NO OPERATOR FOUND MESSAGE?
CHECK AN****A PAD OR AN****A PAD INTERFACE
40%AN****A SWITCH PROBLEM CHNAGE (AN****A SWITCH)

2)(B)MANNUL SEARCHING TIME PHONE GOING TO LONG SEARCH?
FIRST CHANGE, C7524 OR C7573 CAPACITOR

AFTER CHANGE THIS CAPACITOR SAME CONDITION UR PHONE?
SECOND CHECK OR CHNAGE G7500 VCO OR SECOND LOCAL CRYSTAL(38.4Mhz)

NOT SOLVED UR PROBLEM?
REBALL OR CHANGE VINKU

 

[JannatLui]

nokia 1110,1600,2310,6030 etc network soloution
first try with software that means flash with good pm if not solve
then try with hardware


1)CHECK ANTINA
2)CHECK OR CLEAN ANTINA CONNECTOR

3)CHECK PA POWER INPUT WAYS

4)REMOVE PA THEN MAKE JUMBER LIKE THIS PICTURE

AFTER FIX THIS JUMBER!PHONE SHOW SAME NET NO ACCESS PROBLEM?
5)JUST CHANGE RED MARKED RX FILTER OR RESISTER(TX CONTROLL)
LAST TRY TO CHANGE RF IC

ONE THINK UEM OR UPP MAKE NET WORK PROBLEM
65%PROBLEM SOLVED THIS METHODE
20M
15%UPP

FRIENDS PA JUMBER NOT PERMENT SOLUTION CHANGING IS BATTER

 

[JannatLui]

nokia 1110,1600,2310,6030 etc network soloution
first try with software that means flash with good pm if not solve
then try with hardware


1)CHECK ANTINA
2)CHECK OR CLEAN ANTINA CONNECTOR

3)CHECK PA POWER INPUT WAYS

4)REMOVE PA THEN MAKE JUMBER LIKE THIS PICTURE

AFTER FIX THIS JUMBER!PHONE SHOW SAME NET NO ACCESS PROBLEM?
5)JUST CHANGE RED MARKED RX FILTER OR RESISTER(TX CONTROLL)
LAST TRY TO CHANGE RF IC

ONE THINK UEM OR UPP MAKE NET WORK PROBLEM
65%PROBLEM SOLVED THIS METHODE
20M
15%UPP

FRIENDS PA JUMBER NOT PERMENT SOLUTION CHANGING IS BATTER

 

[JannatLui]

brother,software connecting time this error show?
1. BSI line is not connected properly in connector -> Check cable, also for 3.3k resistor in serial with bsi line.
2.UEM damaged -> replace UEM.

THIS ERROR MAINLY BSI LINE RELATED PROBLEM
STEP-1--CHANGE BATTERY
STEP-2--RESOLDRING BATTERY CONNECTOR
STEP-3--REMOVE BSI LINE RELATED CAPACITOR OR VERISTER

STEP-4--CHECK BATTERY CONNECTOR BSI TO BSI LINE RESISTER WAYS

STEP-5--REMOVE BSI RESISTER(vr5)

SAME PROBLEM AGAIN CHANGED vr5 RESISTER
STEP-6--CHANGE BOTTOM EASY CABLE PORT CONNECTOR
PROBLEM SAME REBALL OR CHANGE UEM

 

[JannatLui]

nokia n72,n72 no network found soloution
working process step by step.
first u should write pm then not solve try with hardware.here is details.may it can help u
1st step


2nd step


step 3



step 4


step 5


step 6



step 7



step 8



step 9



step 10




after this work if not solve ur problem do this job now

 

[JannatLui]

NOKIA 7210 SUPERNOVA CHARGER NOT SUPPORTED SOLUTUION

 

[JannatLui]

MY OTHER TECHNICS WITH NOKIA 6500S,5610 ETC.....RESTART SOLVED WITH OUT FLASHING

MANY NOKIA BB5 PHONES SHOW RESTART,NOKIA LOGO ONLY,TIME AND DATE FIXING TIME RESTARTED,HAND SHAKE TIME RESTARTED ETC............
HOW TO SOLVED THIS PROBLEM VIA JAF WITH OUT FLASHING
STEP1-REMOVE BACK COVER AND BATTERY
SETP2-FIX 7.1 RESISTER LIKE THIS PICTURE
(BSI TO GND FIX THIS 7.1 RESISTER WITH BATTERY)

STEP3-INSERT BATTERY WITH HANDSET
STEP4-POWER ON THE PHONE
STEP5-THIS TIME PHONE SHOW LOCAL MODE
STEP6-CONNECT USB CABLE
STEP7-OPEN JAF SOFTWARSTEP8-SELECT COMMUNICATION MODE TO USB
STEP9-USE FULL FACTORY RESET(FACTORY RESET DONE)
STEP10-DISCONNECT PHONE THEN POWER ON WITH OUT SIM
STEP11-GO PHONE SETTINGS RESET COMPLETE PHONE
UR PROBLEM SOLVED 100%.............
TESTED BY ME ABOVE 1000 PHONES
CNT FILE MAKE THIS RESTART PROBLEM

 

[JannatLui]

dear friends how To repair OFFINE MODE OR NO NETWORK N73,N80,N81,N82 ETC................
DONT TOUCH HARDWRAE FIRST
TRY MY TECHNICS
STEP1-FORMAT PHONE WITH BOX(JAF,MT BOX,UFS+HWK ETC.............)
STEP2)DISCOONECT PHONE POWER ON WITH SIM
STEP3)select 'NO' when it asks if you want to start in 'Offline Mode'
STEP4)NOW PHONE TAKE A SIMCARD BUT NOT TAKEN NETWORK
STEP5)HOW TO CHECK THIS NETWORK PROBLEM HARDWRAE OR SOFTWARE?
STEP6)GO TO MENU+TOOLS+SETTINGS+NETWORK+NETWORK MODE CHANGE IT
NOW PHONE RESPOND PHONE CURRENTLLY USED OFFLINE MODE
STEP7)THIS CAUSE 100%SOFTWARE PROBLEM.JUST UPGRADE UR PHONE PROBLEM 100%SOLVED
TESTED BY ME MANY TIME

 

[JannatLui]

SAME NO ACCESS PROBLEM FACED CHANGE PA
POST RESULT

 

[JannatLui]

NOKIA LASTEST MODEL 6208c_6202c_RM-458
KEYPAD AND ON/OFF

DISPLAY

TOUCH SCREEN

MMC