damaged security units, damaged gdfs area,damaged EROM
CID 16,17,24,29,36,37
1. select proper model
2. on settings, check "format gdfs when writing"
3. press recovery
4. add to firmware area proper EROM if applicable
5. press flash
6. add to misc. field gdfs in .bin format/b]
7. press write gdfs
8. press unlock
9. reflash phone
CID 41,42,54,73
disassemble phone.
1. select proper model
2. on settings, check "format gdfs when writing", "use testpoint (gnd method)"
3. add to misc. field gdfs in .bin format/b]
4. press write gdfs
5. press unlock
6. reflash phone
you must use testpoint for such phones (upload testpoint pictures)
CID 49
1. select proper model
2. on settings, check "unlock during flash process"
3. add to firmware area proper gdfs in ssw format
4. if desired, add to firmware area proper main,fsimage
5. press flash
please note, if EROM damaged on such phones, you must execute reset operation.
CID 50,51,52,53
that is so-called reset procedure.
1. go to emptyboard tab
2. select proper model
3. on settings, check "signed mode"
4. press recovery
5. after succeful recovery
6. on settings uncheck all
7. if gdfs totally damaged, add to firmware area proper gdfs in ssw format,otherwise skip that step
8. add to firmware area proper EROM (EROM CID >= OTP CID)
9. press flash
10. if needed,reflash phone on usual semc tab with needed settings.
CID 16,17,24,29,36,37
1. select proper model
2. on settings, check "format gdfs when writing"
3. press recovery
4. add to firmware area proper EROM if applicable
5. press flash
6. add to misc. field gdfs in .bin format/b]
7. press write gdfs
8. press unlock
9. reflash phone
CID 41,42,54,73
disassemble phone.
1. select proper model
2. on settings, check "format gdfs when writing", "use testpoint (gnd method)"
3. add to misc. field gdfs in .bin format/b]
4. press write gdfs
5. press unlock
6. reflash phone
you must use testpoint for such phones (upload testpoint pictures)
CID 49
1. select proper model
2. on settings, check "unlock during flash process"
3. add to firmware area proper gdfs in ssw format
4. if desired, add to firmware area proper main,fsimage
5. press flash
please note, if EROM damaged on such phones, you must execute reset operation.
CID 50,51,52,53
that is so-called reset procedure.
1. go to emptyboard tab
2. select proper model
3. on settings, check "signed mode"
4. press recovery
5. after succeful recovery
6. on settings uncheck all
7. if gdfs totally damaged, add to firmware area proper gdfs in ssw format,otherwise skip that step
8. add to firmware area proper EROM (EROM CID >= OTP CID)
9. press flash
10. if needed,reflash phone on usual semc tab with needed settings.