1. FLASHING VIA USB CABLE:
- To set the phone to flash mode follow the steps below:
1. Phone off with battery (without the USB cable connected to the phone)
2. Hold the (-) the volume down key + number 9 (nine) for a few seconds and then plug the USB cable to the phone.
3. Release the keys of the volume and number 9
Procedure to write the flash file via USB CABLE:
- Select your phone model eg Mxx10
- Select the-------->USB SPEED <---------
- Select the COM port set up after connecting the phone to the PC FLASH MODE eg COM11
- Select the files
- Click on the button FIRMWARE and wait the end.
2. FLASHING VIA RJ45 COM CABLE for DEAD OR ERASED PHONES:
Need make special RJ45 cable with http://forum.gsmhosting.com/vbb/4966748-post8.html
Procedure to write the flash file via RJ45 CABLE:
- Select your phone model eg Mxx10
- Select the COM port of RJ45 cable or BOX Port if you using BOX port.
- Select the speed.
- Select the files
- Click on the button FIRMWARE and wait the end.
by z3x team
- To set the phone to flash mode follow the steps below:
1. Phone off with battery (without the USB cable connected to the phone)
2. Hold the (-) the volume down key + number 9 (nine) for a few seconds and then plug the USB cable to the phone.
3. Release the keys of the volume and number 9
Procedure to write the flash file via USB CABLE:
- Select your phone model eg Mxx10
- Select the-------->USB SPEED <---------
- Select the COM port set up after connecting the phone to the PC FLASH MODE eg COM11
- Select the files
- Click on the button FIRMWARE and wait the end.
2. FLASHING VIA RJ45 COM CABLE for DEAD OR ERASED PHONES:
Need make special RJ45 cable with http://forum.gsmhosting.com/vbb/4966748-post8.html
Procedure to write the flash file via RJ45 CABLE:
- Select your phone model eg Mxx10
- Select the COM port of RJ45 cable or BOX Port if you using BOX port.
- Select the speed.
- Select the files
- Click on the button FIRMWARE and wait the end.
by z3x team