blinking red light solution for all blackberry
new and tried on 100s off bb modules success on all
1. download blackberry master control program and install it
2. download CFP_3.9.0.175.exe keep on desktop
3. open master control program and click on setting wheel on left hand side and
in enable protected control type BrickBerry same as it is here
4. right click on alien face cfp button at left hand side.
5. below in cfp option (rim command-line program (cfp) executable ) select the cfp which you copied on desktop.
6. connect your bb without battery on top command-line interface (CLI)
select wipe tick mark the empty box next to execute and press execute it will take 10 to 12 minutes after it finish disconnect your bb install a battery and wait for few minutes let the phone do its job.
let the bb master control be open..........
now the trick is to load os
1. In bb master control on right hand side below right click on apploader
it will loader/nojvm connect your phone follow the instruction thats it you have done the job..
please write me if you have any doubt or error
thanks
nasir
if gives you error again go to step 6 select nuke and then wipe after this if says error dont cancel the procedure just disconnect the phone remove the battery re insert and wait untill the phone finish then connect the phone and press retry
download link::BLACKBERRY_red_blinking_hangsolution by nasir.rar
instaructions images:step 1. mcp a1.jpg
step 2. cfp setting.bmp
step 3. mcp device pin.bmp
step 4. cfp commands 2.bmp
step 4. os managenent mcp.bmp
if u have any doubt write me
regards
nasir
new and tried on 100s off bb modules success on all
1. download blackberry master control program and install it
2. download CFP_3.9.0.175.exe keep on desktop
3. open master control program and click on setting wheel on left hand side and
in enable protected control type BrickBerry same as it is here
4. right click on alien face cfp button at left hand side.
5. below in cfp option (rim command-line program (cfp) executable ) select the cfp which you copied on desktop.
6. connect your bb without battery on top command-line interface (CLI)
select wipe tick mark the empty box next to execute and press execute it will take 10 to 12 minutes after it finish disconnect your bb install a battery and wait for few minutes let the phone do its job.
let the bb master control be open..........
now the trick is to load os
1. In bb master control on right hand side below right click on apploader
it will loader/nojvm connect your phone follow the instruction thats it you have done the job..
please write me if you have any doubt or error
thanks
nasir
if gives you error again go to step 6 select nuke and then wipe after this if says error dont cancel the procedure just disconnect the phone remove the battery re insert and wait untill the phone finish then connect the phone and press retry
download link::BLACKBERRY_red_blinking_hangsolution by nasir.rar
instaructions images:step 1. mcp a1.jpg
step 2. cfp setting.bmp
step 3. mcp device pin.bmp
step 4. cfp commands 2.bmp
step 4. os managenent mcp.bmp
if u have any doubt write me
regards
nasir