..::Mtk Box-III [Tips-Problem-Solution]::..

[NANAIU]

ERROR
"SPD USB TO SERIAL NOT FOUND"

Solution:
You need to install the USB drivers for SpreadTrum.
If already install than uninstall it first again install SPD the driver.

 

[NANAIU]

ERROR
Error: Unsaft EFS Address, Please input the right format address and try again.
Failed to auto format.

Solution
Try "Reset" option, If still problem than search 4 a same handset read the flashfile from that working set again write it back to the faulty set.

 

[NANAIU]

ERROR
Nor Flash ID: 0000000000000000
Nand Flash ID: 0000000000000000
Nor Flash not found.

Solution
First try to shake the flash ic at middle heat if still same then replace cpu.

 

[NANAIU]

ERROR
Read info is done.
CPU: SC6600R Flash: NOR_K5L6331CAA
Set FLASH Parameters...
Settings have been completed!
Reading FileSystem info...
Failed to read FS info.

Solution
Flash the set with same file or read flash from a working handset and then flash it to faulty handset.

 

[NANAIU]

ERROR
FAILED TO RUN BOOTLOADER

Solution
Press and hold the * button and keep pressed untill all completed if still same shake the flash ic at middle heat.

 

[NANAIU]

ERROR
FAILED TO RXD

Solution
Select 6600l-USB from mode list

 

[NANAIU]

ERROR

Nor Flash ID: 007F22F600000000
Nand Flash ID: 0000000000000000
Read Hardware Information is
Get Project ID from phone...
ProjectID Not Found


Solution
Change the boot type to 3.952 if still same than shake the CPU at middle heat or change CPU

 

[NANAIU]

ERROR
ERROR: MTK_DA_GET_FAT_INFO_NOT_FOUND

Solution
Try Boot "Ver. 3.952" from Boot options, if still same than shake the flash ic at middle heat.

 

[NANAIU]

ERROR
Code:
: Formatting Flash... AutoFormat address: start=0x00E00000, size=0x00200000 Failed to format Flash...
Solution
Try with different Boots from list if still same then rehot flash chip than CPU

 

[NANAIU]

ERROR


Initializing...
DA_LIB_VER_3.2.0.7
It is sensing the pinout fast...
D-=4 D+=3
Searching commport...please wait...


Solution
Check connection with phone or connect from RX TX points from board if still same than rehot the CPU

 

[NANAIU]

ERROR
NOR FLASH NOT FOUND

Solution
There is NAND flash Plz select NAND from Mode and use Boot 3.952