Dragon School<<< Problems and Solutions >>>

[josher]

Mstar Driver Download ​

in some computer,Mstar after pinfind
computer tell you need install the driver


I-run the GPGDragon,
II-select Mstar and click the Start
III-after pinfind computer tip Install Driver

IV-Download the Mstar Driver and install(Like Spd Driver)


Click Download Mstar Driver:

 

[josher]

problem :
Formatting Flash...
AutoFormat address: start=0x00E00000, size=0x00200000
Failed to format Flash...

Try With Diffrents BootsFrom list If Still Same Then Check With Hardware (rehot CPU,FlashChip)

 

[josher]

Initializing...
DA_LIB_VER_3.2.0.7
It is sensing the pinout fast...
D-=19 D+=15
BOOT set failure, continue to scan...

its seems mobile have rx tx on board so check it and connect from rx tx points from board
BR
Faisal_Computer

 

[josher]

<<How to work on GPG DRAGON with Norton AntiVirus>> Open Norton AntiVirus

Br
RIZWAN JAT

 

[josher]

Programming...
Compare Image: Enable
Error: Erase Flash

rehot flash chip and check again software not help you

Initializing...
DA_LIB_VER_3.2.0.7
It is sensing the pinout fast,please hold on the phone Power key
RXD=6 TXD=7
Connecting...Please hold on the POWER key until the red gauge is going...
Failed to read HardCode, REG=0x80000008
Error: Failed to read REG=0x80010008
Error: Failed to read REG=0x84010008
Error: Failed to read REG=0x80001008

Most if time problem comes from bad connection r Bad Flash chip (low Power ) So must check fst cable If Still Same Then Check With hardware

 

[josher]

problem : dragon box start the flashing and stop in 10% again i start flashing and now stop in 40% step by step i am trying but flashing stop in lead some % ?

now what i do this is software problem r hardware ?

Ans : this is software problem and you can solved it just by full erase the whole flash chip

how to erase whole chip flash ?

here is the whole flash chip erase address

for 8MB : 0x00800000
for 16MB: 0x01000000

for 32MB: 0x0200000
for 64MB: 0x0400000


after erase again flash the set and you will be happy to see , in this time flashing not stop to any % complete 100%

NOTE: i Test this method many times and when conform then i post here in forum !

i am sure this method will help a lot of use who face same problem using dragon

 

[josher]

GPGDragon help you slove your Mobile For MTK Chip

this time,have many many customers have a promble
like one MTK mobile,can boot,but can't flash,format,read flash(maybe can)
after will post,why the dragon box no support this mobile
we can say:mobile hardware

why i can say this
when we run the dragon,and boot select inram
we can see the flash is no support
why tip this
when the mobile cpu and flash Communication is not normal
software will tip this
so please try hardware and post the success in the forum

 

[josher]

Disable RTC IRQ failed, REG=0x80210008

Connecter problem !!
clean / change / repair will solve it

Br
Faisal_Computer